The Net Chaser Ethernet Speed Certifier offers a complete solution to test and speed certify the data-carrying capabilities of Ethernet network cables up to 1 Gb/s by testing for noise in the network, detecting faults in the cable wiring, and ensuring that cables are able to support the speed capabilities of active equipment. To certify Ethernet speed performance of cable runs, the Net Chaser conducts Bit Error Rate (BER) tests (using Active Remote) by sending data packets down specified cable runs at defined data rates to check for errors at the maximum throughput of the link. The Net Chaser reports on signal quality that can impact high-speed data transmission by measuring signal-to-noise ratio (SNR). Skew measurements report on the signal time delay between pairs that can impact Gigabit data transmission.
The Net Chaser includes a comprehensive set of features for testing active network capabilities: measure Power over Ethernet (PoE) to ensure the correct power is available on the correct pins, use Port Discovery to ensure the correct speed and duplex capability are available; connect at gigabit Ethernet and run ping tests to verify connectivity to IP hosts; discover network devices using Cisco Discovery Protocol (CDP) or Link Layer Discovery Protocol (LLDP); VLAN discovery; Trace route function displays the path internet packets travel to reach a specified destination. The Net Chaser also saves all test reports and exports to PC’s. Languages: English, Spanish, French, German, Italian.NC950-AR Kit includes: -Net Chaser main unit -Active Remote -Power Supply -4 GB SD card -Micro USB -#1 Testing network remote -Network and coax remote set: #1-5, F-Conn coupler includes foam holder -Network patch cable (2) -Sacrificial cable (2) -T3 hanging strap and clip (2) -Large T3 carrying case