1.Use as Circuit Tester
Connect two alligator clips to the ends of the wire to check if resistance exists. If yes, the wire could be a short or open circuit. You can use the Wire Tracker function to locate the problem.
2.Use as a Wire Tracer
By sending a signal down the wire being tested, you can trace the wire with the detector probe. An audible tone will increase in volume as the probe gets closer to the wire. Even when you have a bundle of wires, you can still find the wire you wish to trace with the help of the volume knob.Note:In a noisy environment, you can put on the headset and adjust it to a proper volume to avoid the interference.
3.Low Battery Capacity Indication
Move the function selector switch of the emitter to the "SCAN"position,when the cell voltage is below 6.0V?the STATUS indicator and the VERIFY indicator of the emitter can flash at the same time.
Please make sure that the wires you are going to test are in low-electricity or power-off condition ,for the maximum currents for emitter and receiver are 10mA and 30mA respectively.Remove the battery when you don't use the device for a long time?and the signal transmission distance may be influenced by the energy of batteries.
1.Power specs:DC,9V laminated battery( included)
2.Max. operating current:Emitter ?10mA; Receiver?30mA
3.Signal transmission format: Multi-frequency pulse
4Signal output level:8Vp-p
5.Signal transmission distance:.?3km
1 * Emitter
1 * receiver
1 * earphone
1 * RJ11 adapter
1 * RJ45 adapter
1 * alligator clip adapter
1 * Toolkit
1 * User manual
2 * 9V Battery
Please feel free to contact us when you have any problem,we will give you the best service and solve the problem ASAP.Thank you so much!